Alarm System - Alfa Romeo Giulia 952 2017 Owner's Handbook Manual

the engine, contact an Alfa Romeo
Dealership.
If the icon is displayed while driving,
this means that the system is running a
self-diagnosis (e.g. due to a voltage drop).
If the display persists, contact an Alfa
Romeo Dealership.
IMPORTANT NOTES
Do not tamper with the Engine
Immobilizer system. Any modifications/
alterations could cause the protection
function to be deactivated.
The Engine Immobilizer system is not
compatible with certain aftermarket
remote starting systems. The use of
these devices could cause problems
when starting and the deactivation of the
protection function.
All keys provided with the vehicle have
been programmed in accordance with the
electronics on the vehicle itself.
Each key has its own code which must be
stored by the system's control unit.
Contact an Alfa Romeo Dealership to
have new keys (up to 8) stored with a
code.
24

ALARM SYSTEM

(where provided)
ALARM ACTIVATION
The alarm goes off in the following cases:
wrongful opening of doors/bonnet/
boot (perimeter protection);
operation of starting device with a key
which is not validated;
cutting of the battery leads;
movement inside the passenger
compartment (volumetric protection,
where provided);
anomalous lifting/tilting of the car
(anti-lift protection, where provided).
Activation of the alarm triggers the
acoustic warning and the direction
indicators.
IMPORTANT The function is ensured by
the Engine Immobilizer system, which is
automatically activated when you get out
of the vehicle taking the electronic key
with you and locking the doors.
IMPORTANT The alarm is adapted to
meet requirements in various countries.
SWITCHING ON THE ALARM
With the doors, bonnet and tailgate
closed and the ignition device turned to
STOP, point the electronic key towards
the vehicle and press and release button
. The alarm can also be engaged by
pressing the "door lock" button, located
on the door external handle. For further
information see the "Passive Entry" item
in the "Doors" paragraph.
Except on some versions for specific
markets, the system produces a visual
and acoustic warning and enables door
locking.
With the alarm engaged, the warning
lights on the panels of the front door
handles flash fig. 15.
15
The activation of the alarm is preceded
by a self-diagnosis stage: if a fault is
detected, the system emits a further
acoustic signal.
If, after the alarm is switched on, a
second acoustic signal is emitted, wait
about 4 seconds and switch off the alarm
by pressing the button, check that the
doors, bonnet and boot are closed
correctly and then reactivate the system
by pressing the button.
If the alarm emits an acoustic signal even
when the doors, bonnet and boot are
correctly closed, a fault has occurred in
04046S0001EM