Table of Contents
Advertisement
advisable to replace it with a genuine
spare part, specifically designed for this
vehicle.
AIR FILTER
171)
Replacing the air cleaner
See the "Scheduled servicing plan" for
the correct servicing intervals. It is
advisable to replace it with a genuine
spare part, specifically designed for this
vehicle.
AIR CONDITIONING SYSTEM
MAINTENANCE
79) 80)
To ensure the best possible performance,
the air conditioning system must be
checked and undergo maintenance at an
Alfa Romeo Dealership at the beginning
of the summer.
IMPORTANT Do not use chemicals to
clean the air conditioning system, since
the internal components may be
damaged. This kind of damage is not
covered by warranty.
Replace the pollen filter
See the "Scheduled servicing plan" for
the correct servicing intervals. For
cleaner replacement, contact an Alfa
Romeo Dealership.
230
LUBRICATING MOVING PARTS OF THE
BODYWORK
Ensure that the locks and bodywork
junction points, including components
such as the seat guides, door hinges (and
rollers), boot and bonnet are periodically
lubricated with lithium-based grease to
ensure correct, silent operation and to
protect them from rust and wear.
Thoroughly clean the components,
eliminating every trace of dirt and dust.
After lubricating, eliminate excess oil and
grease. Also pay particular attention to
the bonnet closing devices, to ensure
correct operation. During operations on
the bonnet, to be carried out with the
engine cold, also remember to check,
clean and lubricate the locking, release
and safety devices.
Lubricate the external lock barrels twice
a year. Apply a small amount of
high-quality lubricant directly into the
lock barrel.
If necessary, contact an Alfa Romeo
Dealership as soon as possible.
WINDSCREEN WIPER
Periodically clean the windscreen and
rear window and rubber profile of the
windscreen wiper blades, using a sponge
or a soft cloth and a non-abrasive
detergent. This eliminates the salt or
impurities accumulated while driving.
Prolonged operation of the windscreen
window wipers with dry glass may cause
the deterioration of the blades, in
addition to abrasion of the surface of the
glass. To eliminate the impurities on the
dry glass, always operate the windscreen
washers.
In the event of very low outdoor
temperatures, below zero degrees,
ensure that the movement of the rubber
part in contact with the glass is not
obstructed. Use a suitable deicing
product to release it if required.
Avoid using the windscreen wipers to
remove frost or ice.
Also avoid contact of the rubber profile
of the blades with petroleum derivatives
such as engine oil, petrol, etc.
IMPORTANT The envisaged life of the
windscreen wiper blades varies
according to the usage frequency. In any
case, it is advisable to replace the blades
approximately once a year. When the
blades are worn, noise, marks on the
glass or streaks of water may be noticed.
In the presence of these conditions, clean
the windscreen wiper blades or, if
necessary, replace them.
IMPORTANT Driving with worn
windscreen wiper blades is a serious risk,
because visibility is reduced in bad
weather conditions.
Raising the windscreen wiper blades
("Service position" function)
The "Service position" function allows the
driver to replace the windscreen wiper
blades more easily. It is also
recommended to activate this function
Advertisement
Chapters
Table of Contents
