Electric Parking Brake - Alfa Romeo Giulia 952 2017 Owner's Handbook Manual

Table of Contents

Advertisement

excessive heat from combustion
chamber, bearings, inner components and
turbocharger.
WARNING
106) It is dangerous to run the engine in
enclosed areas. The engine takes in oxygen
and releases carbon dioxide, carbon
monoxide and other toxic gases.
107) The electro-hydraulic braking system
is not active until the engine starts running.
So, the brake pedal travel will be longer than
normal. This does not indicate a fault.
108) Do not start the engine by pushing,
towing or driving downhill. These
manoeuvres may damage the catalytic
converter.
IMPORTANT
32) We recommend that during the initial
period, or during the first 1600 km
(1000 miles), you do not drive to full car
performance (e.g. excessive acceleration,
long journeys at top speed, sharp braking,
etc.).
33) When the engine stopped never leave
the ignition device in the ON position to
prevent useless current draw from draining
the battery.
34) Warning light
will flash after starting
or during prolonged cranking to indicate a
fault with the glow plug heating system. If
the engine starts, the vehicle can be regularly
used, but an Alfa Romeo Dealership must be
contacted as soon as possible.
144
35) A quick burst on the accelerator before
turning off the engine serves absolutely no
practical purpose; it wastes fuel and is
damaging for the engine.

ELECTRIC PARKING BRAKE

ELECTRIC PARKING BRAKE
The car is equipped with electric parking
brake to guarantee better use and
optimal performance compared to a
manually operated parking brake.
The electric parking brake features a
switch, located on the central tunnel
fig. 146, a motor with caliper for each
rear wheel and an electronic control
module.
146
The electric parking brake can be
engaged in two ways:
manually, by pulling the switch on the
central tunnel;
automatically in "Safe Hold" or "Auto
Park Brake" conditions.
IMPORTANT Normally, the electric
parking brake is engaged automatically
when the engine is stopped. This function
can be deactivated/activated on the
Connect system by selecting the
07046S0001EM

Advertisement

Table of Contents
loading

Table of Contents