Installation Tips; Wall Mounting - BEA IS40 User Manual

3 PRECAUTIONS
This device IS NOT intended for use as a safety sensor.

!
Not recommended for dynamic envioronments. (snow, rain, fog, etc.)

Shut off all power before attempting any wiring procedures.

CAUTION
Maintain a clean & safe environment when working in public areas.

Constantly be aware of pedestrian/vehicle traffic around the area.

Always stop pedestrian/vehicle traffic through the doorway when performing tests that may result in unexpected reactions by the door.

ESD electrostatic discharge: Circuit boards are vulnerable to damage by electrostatic discharge. Before handling any board ensure

you dissipate your body's charge.
Always check placement of all wiring before powering up to insure that moving parts will not catch any wires and cause damage to

equipment.
Ensure compliance with all applicable safety standards upon completion of installation.

DO NOT attempt any internal repair of the sensor. All repairs and/or component replacements must be performed by BEA Inc. Unau-

thorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. May adversely affect the safe and reliable performance of the product and will result in a voided product warranty.
4
DIMENSIONS

Wall mounting

5

INSTALLATION TIPS

The sensor must be
firmly fastened to
prevent vibration.
6 MOUNTING
Remove the bracket from the sensor.
Drill 2 holes accordingly. If necessary, drill an additional
hole to facilitate wire routing. Fix the bracket firmly.
Page 2 of 9
3
6.25
Ceiling mounting
DO NOT cover
Avoid exposing the
the sensor.
sensor to sudden
temperature changes
2.5
1 9/16
1 1/16
6.25
Bracket dimensions
Avoid proximity to neon
lamps, fluorescent lights
or moving objects
Position the sensor on the bracket
and fasten the angle adjustment screws.
1 1/2
1 1/4
1/2
1 1/16 1 1/16
4 1/8
The sensor must not
have any object likely
to move or vibrate in
its sensing field.
75.5695.01 EN 20120113