Table of Contents
Advertisement
C C o o r r d d l l e e s s s s T T e e l l e e p p h h o o n n e e O O p p e e r r a a t t i i o o n n
H H e e a a d d s s e e t t F F e e a a t t u u r r e e
Your HANDSET, when connected to a headset (not
included),
will
provide
communication. Pull out the HEADSET JACK COVER,
then insert the small plug at the end of the headset into
the HEADSET JACK at the left side of the HANDSET.
Follow the procedures discussed in "Receiving Calls"
and "Placing Calls" to receive and place a call.
NOTE: When you plug the headset plug into the
HEADSET JACK it automatically mutes the
MICROPHONE
and
HANDSET. Unplug the headset to return the
HANDSET to normal use.
Headsets are available at most retail outlets that sell
telephone equipment. The HEADSET JACK is
compatible with 2.5mm headset plugs only.
R R e e d d i i a a l l F F e e a a t t u u r r e e
1. If you get a busy tone, press the
place the HANDSET on the BASE UNIT to hang up.
2. Later, press the
talk
button again.
3. Listen for a dial tone.
4. Press the
button. This will automatically redial
the last telephone number you called in TALK mode.
5. When you have finished with your call, press the
button again (the BASE UNIT IN USE LED
talk
indicator will turn off) or place the HANDSET on the
BASE UNIT.
NOTE:
If you are too far away from the BASE UNIT, the HANDSET emits "beep" sounds to warn you
that the background noise level is too high for proper communication between the HANDSET
and the BASE UNIT. When you hear this sound, you should move closer to the BASE UNIT to
reduce the noise level. Otherwise, the call will automatically cut off.
you
with
hands-free
SPEAKER
of
the
button or
talk
13
Advertisement
Table of Contents
