Advertisement
ASSEMBLY
Your new tractor has been assembled at the factory with exceptton of those parts left unassembled for shipping purposes. To
ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set wdl make assembly easier. Standard
wrench stzes are hsted
Ut_[tty knife
Phers
(1) 3/4" wrenches
Tire pressure gauge
(2) 7/16" wrenches
When nght or left hand tsmentioned tnthLs manual, _tmeans
when you are _nthe operatmg pos_t_on(seated behind the
steenng wheel).
TO REMOVE TRACTOR
FROM CARTON
UNPACK
CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Cut, from top to bottom, along hnes on all four comers
of carton, and lay panels flat.
•
Check for any addtttonal loose parts or cartons and
remove.
BEFORE REMOVING
TRACTOR
FROM
SKID
ATTACH
STEERING
WHEEL
(See Fig. 1)
ASSEMBLE
EXTENSION
SHAFT
AND BOOT
Slide extension
shaft onto lower steenng
shaft
Align
mountLng holes m extension and lower shafts and install
1/4 hex bolt and Iocknut
Tighten securely.
IMPORTANT
TIGHTEN
BOLT AND NUT SECURELY
TO
10-12 FT LBS TORQUE
Place tabs of steering boot over tab slots in dash and push
down to secure
INSTALL
STEERING
WHEEL
Posihon front wheels of the tractor so they are pointing
straight forward
Remove steering wheel adapter from steenng wheel and
slide adapter onto steenng shaft extension.
Position steenng wheel so cross bars are honzontal (left to
nght) and shde inside boot and onto adapter
•
Assemble large flat washer,
1/2 hex nut and tighten se-
curely
Snap steenng wheel insert into center of steenng wheel.
Remove protective materials from tractor hood and gnll
IMPORTANT:
CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE
TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.
EXTENSION
SHAFT
1/4 HEX BOLT
FIG. 1
HOW TO SET UP YOUR TRACTOR
CHECK
BATTERY
(See Fig. 2)
Lift seat pan to raised position.
If this battery is put mto service after month and year
mdlcated on label (label located between terminals)
charge battery for mtmmum of one hour at 6-10 amps.
(See "BA'I-FERY" in CUSTOMER RESPONSIBILITIES
section of this manual for charging mstructions).
6
Advertisement
