3 Monitoring
Chapter 3 Monitoring
3.1 Monitoring the Dial Routing Interface
This section describes the commands used to monitor the state of the Dial Routing interface links and connections.
To access this monitoring, introduce the following commands:
*monitor
Console Operator
+network <interface_name>
-- Interface <interface_name> Console --
DR monitor+
Example:
*monitor
Console Operator
+network dialroute1
-- Interface dialroute1 Console --
DR monitor+
The following commands are available in the interface console:
Command
? (AYUDA)
LIST
EXIT
3.1.1 ? (HELP)
Use the ? (HELP) command to list the commands available at the layer where the router is monitoring. You can also
use this command after a specific command to list its options.
Syntax:
DR monitor+?
Example:
DR monitor+?
list
Show monitoring information
exit
DR monitor+
3.1.2 Displaying the monitoring information
Once you have selected the LIST command, you can see the available options by using the help command:
DR monitor+list ?
all
connections
links
DR monitor+
3.1.2.1 Monitoring information completed
To list both the state of the PPP interfaces participating in the Dial Routing process, as well as the status of the Dial
Routing connections in an interface, use the following command:
Syntax:
DR monitor+list all
Example:
DR monitor+list all
36
Function
Lists the commands or their options.
Displays the Dial Routing interface monitoring information.
Exits the interface monitoring console.
Information about links and connections
Status of the Dial Routing connections
State of the participating PPP interfaces
Alcatel-Lucent Enterprise
Dial Routing