Table of Contents
Advertisement
Alcatel-Lucent Enterprise
network dialroute2
; -- DR interface configuration --
no ip address
;
exit
;
;
;
dump-command-errors
end
; --- end ---
Config>
1.5.2 Configuring the Dial Routing Interfaces
Dial Routing interface configuration consists of two main steps.
The first step is to configure the name of the Pool corresponding to the interface. This pool name joins the interface
with the PPP interfaces that can be used to carry out the connections. This must be the same as that configured
when enabling Dial Routing in the PPP interfaces.
The second step is to configure the connection destinations that are going to be carried out through this interface.
There also exists the possibility of configuring a time period in which a PPP interface will remain in quarantine (i.e.
without being used by the Dial Routing) when a local error occurs (failure to establish the physical level in the ISDN
interface for example).
Below we will show how to configure the first two parameters which are vital. To see all the configuration possibilities,
please see the section on configuration commands further on in this manual.
1.5.2.1 Configuring the Pool name
As already indicated, you need to configure a pool name that refers to the PPP interfaces in order to "register" these
in a Dial Routing interface on starting up the device. The command used to configure this parameter is displayed be-
low where we will configure "ISDN" as the pool name so the Dial Routing manages the ISDN connections and
"PSTN" for managing connections via the modem.
Config>network dialroute1
-- DR interface configuration --
dialroute1 config>pool-name RDSI
dialroute1 config>list interface
Interface Configuration
-----------------------
Pool Name:
Quarantine time:
dialroute1 config>exit
Config>network dialroute2
-- DR interface configuration --
dialroute2 config> pool-name RTC
dialroute2 config>list interface
Interface Configuration
-----------------------
Pool Name:
Quarantine time:
dialroute2 config>
The following list shows the router global configuration once this operation has been completed.
dialroute2 config>exit
Config>show config
; Showing System Configuration for access-level 15 ...
; OA5058 Router
log-command-errors
no configuration
add device ppp 1
add device ppp 2
add device ppp 3
Dial Routing
RDSI
4 min.
RTC
4 min.
1 Introduction
7
Advertisement
Table of Contents
