Selecting A Magazine - Siemens SINUMERIK 840D sl Operating Manual

Tool management
13.5 Tool list
Multiple load points
If you have configured several loading points for a magazine, then the "Loading Point
Selection" window appears after pressing the "Load" softkey.
Select the required loading point and confirm with "OK".
Unloading tools
13.5.7

Selecting a magazine

You can directly select the buffer memory, the magazine, or the NC memory.
Procedure
646
1. Place the cursor on the tool that you would like to unload from the mag‐
azine and press the "Unload" softkey.
2. Select the required load point in the "Loading Point Selection" window.
3. Confirm your selection with "OK".
- OR -
Undo your selection with "Cancel".
1. The tool list is opened.
2. Press the "Magazine selection" softkey.
If there is only one magazine, you will move from one area to the next
(i.e. from the buffer memory to the magazine, from the magazine to the
NC memory, and from the NC memory back to the buffer memory) each
time you press the softkey. The cursor is positioned at the beginning of
the magazine each time.
- OR -
If there is more than one magazine, the "Magazine Selection" window
opens. Position the cursor on the desired magazine in this window and
press the "Go to" softkey.
The cursor jumps directly to the beginning of the specified magazine.
Operating Manual, 05/2017, A5E40868956
Milling