Plunge Turning Residual Material (Cycle952) - Siemens SINUMERIK 840D sl Operating Manual

Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description
Residual material Without subsequent residual material removal
PL Machining plane
SC Safety clearance
DI Continuous cut - (only for ∇)
Set machining area Set machining area limits
limits
N Number of grooves
10.5.12

Plunge turning residual material (CYCLE952)

Function
The "Plunge turning residual material" function is used when you want to machine the material
that remained after plunge turning.
For a G code program, select the function in the screen. Material that remains as part of the
finishing allowance is not residual material. The "Plunge turning residual material" function
allows you to remove unwanted material with a suitable tool.
The "Plunge turning residual material" function is a software option.
Procedure
Milling
Operating Manual, 05/2017, A5E40868956
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" and "Contour turning" softkeys.
3. Press the "Plunge turning residual material" softkey.
The "Plunge turning residual material" input window opens.
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Value
No
Defined in MD
52005
1 mm
0
No
1
Can be set in SD
x
573