Attaching Wires - AMX DGX1600-ENC Hardware Reference Manual

4.
AIE slot numbering
in DGX 64
FIG. 100

Attaching Wires

When attaching audio wires, you may find it easier to unplug the audio connectors before you start.
For connector details, see Audio Specifications on page 155.
Important to Know When Wiring AIE Boards
CAUTION: Connecting AIE output left and Right channels to the same point to obtain a single channel may damage the AIE Board.
NOTE: If wiring the audio connectors to balanced audio input devices, see page 162 for options.
To wire audio connectors:
1.
2.
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
Repeat Steps 1 through 3 as necessary for the remaining overlays.
AIE Board slot numbering on Enova DGX 6400
Audio boards and connectors are positioned vertically on the Enova DGX 3200 and horizontally on the

Enova DGX 800/1600/6400. Be sure to note the labeling for the wiring on the "R" (right channel) and the "L" (left channel)
wires in FIG. 101.
Enova DGX 800/1600/6400 only – the orientation of Audio Insert/Extract Board in the right expansion slot places the

number 1 audio connector on the far right of the board.
Press a very small tip screwdriver (or a T-pin) into the square hole to release the tension clamp (if the clamp does not release
fully, you may need to use the screwdriver as a lever to release it).
Insert the wire into the round hole.
Enova DGX Audio Insert/Extract Boards
AIE Board Slots
160