Roland G-70 Service Notes page 22

The display shows:
Press the switch "USER PROGRAM 1".
The display shows:
The G-70 will make a deep check of the system file; should the file be correct, it will
start the updating. A progression bar will show its status.
At the end of the updating, switch off the instrument.
D. Factory Reset
Switch on the instrument.
Press the switch MENU.
Press the button "UTILITY" on the touch screen.
Press "FACTORY RESET"
Press "EXECUTE" and wait until the operation is completed.
Mode 2 - Updating the Operative System by means of USB connection
A. Copy the operative system into the "UPDATE" directory of the built-in memory
Connect the G-70 to a PC by means of a USB cable.
Press the switch MENU.
Press the button "USB DATA STORAGE" on the touch screen.
Press "INTERNAL MEMORY".
A new G-70 virtual drive will appear on the Computer Resources (the directory "UPDATE"
will be created within it).
Open the folder previously created in the PC containing the operative system.
Copy, selecting and drawing the file "G70_Ver_01_XX.sys" of the operative system
from the PC into the "UPDATE" directory of the built-in memory.
- SYSTEM UPDATE -
You can use Internal or Card Memory
a) Put in the System file in the UPDATE Folder
b) After copying, safely close USB connection from PC
c) Press user PROGRAM switch (1) to update
- SYSTEM UPDATE -
You can use Internal or Card Memory
a) Put in the System file in the UPDATE Folder
b) After copying, safely close USB connection from PC
c) Press user PROGRAM switch (1) to update
Updating by Card
B: \ Update \\ G-70_ xxxxxx_xxxxxx_Build xx. sys
Power Off And power On again
G-70
27