Stanley MC521 Pro Installation And Operation Manual page 7

Step 7: Press Begin AutoConfigure
Step 9: Put door fuction switch to Hold Open then
immediately back to Closed. The same function can
be done remotely from the Palm by pressing
Operate.
WARNING: During this sequence the sensors
are inactive and the door has no SAFETY. To
stop the door, turn power off or put the doors
into breakout.
Door will go through a learn sequence
Step 11:
to configure itself. The door will perform the
following operations in learn mode:

Open fully at check speed.

Close fully at check speed.
© 2010, THE STANLEY WORKS. ALL RIGHTS RESERVED.
Step 8: Press OK.
r
Step 10: For all doors except cart doors press
Motor 1 to operate and have door(s) move. For
cart doors, press Motor 2 when configuring the
second door.
Step 12: If the door is not operating correctly select
Trouble Shoot to enter the Trouble Shooting menu.
204066
Rev. A, 11/23/10
6 of 27