Alarm Indicators; How To Configure Sonet; Prerequisites For Configuring Sonet; Configuring Mediatype Controller - Cisco ASR 900 Series Configuration Manual

Configuring SONET

Alarm Indicators

Typically, a failure condition detected by a SONET chassis results in one or more error conditions sent both
upstream and downstream on the network. An AIS is sent in order to alert downstream chassis of a problem
and in order to prevent consequential downstream failures or alarms from being raised.

How to Configure SONET

This section describes how to configure SONET.
Each SFP port (0-7) can be configured as OC-3, OC-12, OC-48, or Gigabit Ethernet. SFP+ port (8) can be
configured as OC-192 or 10 Gigabit Ethernet.
Note To use the above features, you need to apply a valid license.

Prerequisites for Configuring SONET

You must select the MediaType controller to configure and enter the controller configuration mode.
You must configure the controller as a SONET port.

Configuring MediaType Controller

To configure MediaType Controller, use the following commands:
enable
configure terminal
controller MediaType 0/0/16
mode sonet
end

Configuring SONET Ports

To configure SONET ports, use the following commands:
enable
configure terminal
controller MediaType 0/0/16
mode sonet
controller sonet 0/0/16
rate OC12
end
The above example shows how to configure SONET ports in OC-12 mode.

Managing and Monitoring SONET Line

This section describes how to manage and monitor SONET.
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco IOS
Alarm Indicators
XE Fuji 16.7.x (Cisco ASR 900 Series)
75