Reviewing And Deleting Stored Images - Fluke Ti9 User Manual

Setting the Temperature Span (Manual)
When put into manual ranging, the span setting adjusts the palette over a
temperature range within the total range of the Imager. See Figure 1. To
adjust the temperature span:
1. After entering the manual range mode (See the "Setting the
Range" section above), press the softkey labeled Span.
2. Press the softkey labeled Increase to widen the temperature span
or Decrease to narrow it.
3. Press the softkey labeled Done to set the Imager's range level.
Switching Between PIP and Full IR
The Imager can be set to display a full infrared image (Full IR) or an infrared
image surrounded by a visual light image (Picture-in-Picture / PIP). To
switch the r TiR Imagers between a full infrared display and Picture-In-
Picture (PIP) display:
1. Press F2 until IR Fusion appears over F3d.
2. Press the softkey labeled Up or Down to toggle the display between
PIP and Full IR.
3. Press the softkey labeled Back/Done when finished.

Reviewing and Deleting Stored Images

To view stored images on the SD card:
1. Press a until Memory appears over c.
2. Press the softkey labeled Memory to reveal the review menu.
3. Press the softkey labeled Review.
4. Press the softkey labeled Up to display the previous image or Down to
display the next stored image.
To delete a single Image from the SD card:
1. Perform the steps under viewing stored images above to bring the desired
image to the display.
2. Press the softkey labeled Select.
3. Press the softkey labeled Delete.