SRAM level ultimate Service Manual page 36

14
Install the compression fitting and nut into the lever.
15
Tighten the compression nut.
Clean the lever.
Slide the hose boot onto the compression nut.
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions,
This concludes the Level™ Ultimate, Level TLM, and Level TL Brake Service,
8 mm Flare Nut
⚠ CAUTI ON
visit www.sram.com/service.
8 N·m (71 in-lbs)
Lever Blade Installation 36