SRAM level ultimate Service Manual page 35

10
Cut the hose to install a new barb and compression fitting.
You must install a new hose barb and compression fitting before recon-
necting the brake lever to the hose.
11 Apply DOT grease to the hose barb threads. Thread the hose barb into
the hose until it is flush with the end of the hose.
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
12
Install the compression nut onto the hose.
13
Thread the compression fitting over the hose barb, counter-clockwise,
until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.
Apply DOT grease to the outside of the compression fitting and the
threads of the compression nut.
NOTI CE
NOTI CE
SRAM Hydraulic Hose Cutter
T8 DOT Grease
T8
DOT Grease
Lever Blade Installation 35