Advertisement
(When the TOT Penalty is set, transmission can not be done even if you turn OFF
the PTT then ON again within the programmed time.)
6-12 TOT Penalty Function
When the transmission is completed by the TOT function, the transmission will be
inhibited within the programmed TOT Penalty time. The transmission is inhibited
during the penalty time.
1. TOT Penalty function and its penalty time can be programmed in the set mode.
If the PTT key is pressed during the TOT Penalty time, an alarm tone will sound.
2. The penalty will be cancelled if you keep holding down the PTT key until TOT
expires and also TOT Penalty time elapses.
5-13 BCLO (Busy Channel Lock Out) Function
BCLO disables the transmission according to the receiving condition.
. BCLO function can be turned ON/OFF in the set mode.
. When the BCLO is set, transmission is possible only in following cases and
transmission is inhibited in the other cases.
If PTT key is pressed while the transmission is inhibited, an alarm tone will sound.
In this time transmission is deactivate.
1. No signal is picked up. (BUSY disappears.)
2. The tone frequencies match and the squelch is opened while using the tone squelch.
3. The codes match and the squelch is opened while using DCS.
7 Operation 3 （ Others）
7-1 Cable Clone
With an interface cable the entire memory channel data of one transceiver can be
transferred and copied to another transceiver.
【Connection】
As shown in the figure, connect the external speaker jacks of two transceivers;
transmitting side and receiving side, with 3.5mm stereo plug cord on the market.
. Be sure to turn the power OFF at cable connecting.
. Please use the directly connected cable including no resistors inside. Be careful not
to use the cable that contains any resisters.
【Operation of data receiving side】
1. Turn the power ON.（The unit enters the data receiving mode.）
2. When the data is sent from the transmitting side, "LD ***" appears on the LCD.
Then the data transfer is started.
3. When the transfer is completed, "PASS" is appears on the LCD.
Turn the power OFF. If the data transfer is failed, "PASS" does not appear on the LCD.
【Operation of data transmitting side】
1. Turn the power ON.
2. Press and hold the MON key, then press the PTT key 3 times, "CLONE" will
appear on the LCD. The unit enters the Clone mode.
3. Press the PTT key, "SD 000" appears on the LCD. The internal memory channel
Advertisement
