Table Tilt Rack & Pinion Assembly
1.
DISCONNECT BANDSAW FROM POWER!
2.
With the table perpendicular to the blade,
wipe off all existing grease and sawdust
buildup from the rack.
3.
Move the table up to its maximum 45˚ angle
and wipe (Figure 67) off all existing grease
and sawdust buildup from the rack.
Figure 67. Table tilt rack and pinion assembly.
4.
Apply a thin coat of light all-purpose grease to
the rack.
5.
Move the table up and down several times
to distribute the grease, then wipe off any
excess grease.
-48-
Trunnions
1.
DISCONNECT BANDSAW FROM POWER!
2.
Move the table up until it reaches its maximum
45˚ angle and wipe off all excess grease and
sawdust from the trunnions.
3.
Apply a thin coat of light all purpose grease to
the trunnions (Figure 68).
Figure 68. Trunnion lubrication location.
4.
Move the table down and then back up to dis-
tribute the grease, then wipe off any excess
grease from the trunnions.
Model G0636X/G0636XB (Mfd. Since 04/17)