Installing Fence - Grizzly G0636X Owner's Manual

Installing Fence

1. Remove the cap screw, knobs, and washers
that hold the rail onto the table, then remove
the rail.
2.
Flip the rail over and reinstall with the fast-
ners removed in Step 1.
3. Install the fence handle on the fence, if it is
not already installed.
4. Tighten the hex nut on the fence handle
against the fence pivot block (Figure 17).
Pivot Block
Fence
Handle
Figure 17. Fence handle components.
5.
Install the resaw fence lock handle (with the
8mm washer and moving plate) onto the
fence, then slide the resaw fence over the
moving plate as shown in Figure 18.
Note: Leave the moving plate and lock
handle loose enough to slide on the resaw
fence.
Model G0636X/G0636XB (Mfd. Since 04/17)
Hex Nut
Resaw Fence
Resaw Lock
Handle
Figure 18. Example of attaching resaw fence to
standard fence.
6.
Tighten the resaw lock handle.
7.
Pull the fence handle up and place the fence
assembly on the rail.
8.
Push the fence handle down to lock the fence
assembly in place.
Moving
Plate
-21-