Table of Contents
Advertisement
3.1.4 Removing the MAIN BOARD assembly (See Fig.8 to 11)
(1) Disconnect the card wire from MAIN BOARD assembly
connected to connector
bly. (See Fig.8)
(2) Disconnect the connector wire from DOOR SWITCH con-
nected to connector
CN404
bly. (See Fig.9)
(3) Disconnect the connector wire from CONTROL BOARD
assembly connected to connector
BOARD assembly. (See Fig.9)
(4) Disconnect the connector wire from USB BOARD assem-
bly connected to connector
assembly. (See Fig.9)
(5) Remove the two screws H attaching the MAIN BOARD as-
sembly. (See Fig.9)
(6) Disconnect the connector wire from MAIN BOARD assem-
bly connected to connector
sembly. (See Fig.10)
(7) Remove the solder the soldering earth wire from MAIN
BOARD assembly soldering to USB BOARD assembly.
(See Fig11)
CN710
CN404
CN710
of the CD BOARD assem-
of the MAIN BOARD assem-
CN403
of the MAIN
CN302
of the MAIN BOARD
CN702
of the CD BOARD as-
Fig.8
H
CN302 CN403
Fig.9
CN702
Fig.10
solder
Fig.11
(No.MB634)1-9
Advertisement
Table of Contents
