Lighting And Start-Up Instructions; Warranty Time Allowance Chart - Norcold 1082 Service Manual

Lighting and Start Up Instructions
Lighting Instructions - Gas Operation
WARNING: Hazardous Vapors. Holding the gas valve (C) in without flame ignition will cause gas to
build-up in the burner area and can result in severe personal injury, property damage, or death. Do
not hold the gas valve in for more than 30 seconds. If the flame is not indicated within this time,
turn the mode selector knob to OFF, wait 2 minutes, and retry. If the flame still will not ignite, shut
the refrigerator off and contact a service repair technician.
To light the refrigerator:
1. Turn on the gas supply to the refrigerator.
2. Set the thermostat (B) to it's maximum setting.
3. Push and turn the "Elec-Off-Gas" (C) knob counter-clockwise
to the "Gas" position.
4. Hold the control knob (C) in and push the igniter (A) repeatedly
until the gas is lit at the burner.
5. When the flame indicator (D) starts to move, stop pushing the
igniter. Continue to hold the control knob in for approximately 5
seconds, then release. The flame indicator needle should re-
main in the green area indicating the flame is present at the
burner. If not, repeat steps 4 and 5.
The flame should ignite within 10 seconds. On initial refrigerator
Start-Up, it may take longer than 10 seconds to allow air to be
purged from the propane gas supply line.
6. Set thermostat control (B) to desired setting after initial cool
down.
Shutdown - All Modes
1. Push and turn the "Elec-Off-Gas" (C) control knob to the "Off"
position.
Warranty Time Allowance
• Norcold will pay the time allowance multiplied by the service facility prevailing shop labor rate.
• The time allowances which follow include diagnostic times include defective part replacement and gas leak
test times (when applicable).
• A gas leak test is required when gas connections, either the main gas supply line to the refrigerator or the
refrigerator gas components have been disconnected.
Replacement Part
Burner
Combination Control
Cooling Unit
Door Handle (parts of)
Electrode (Ignition)
Flame Indicator Light

Warranty Time Allowance Chart

Time allowance
.5 HR.
1.0 HR.
1.5 HR. Thermocouple Adapter
.3 HR.
.5 HR.
.3 HR.
5
A
Start-Up Instructions - AC Operation
1. Make certain 110 volts AC are avail-
able to the refrigerator.
2. Set thermostat to maximum setting.
3. Push and turn "Elec-Off-Gas" control
knob clockwise to "Elec". Upon re-
lease, the knob will move outward,
indicating the control is locked into
electric operation.
Replacement Part
Flame Meter
Heater (AC)
Orifice/Orifice Gasket
Spark Ignitor (Piezo)
Thermocouple
Figure 7
D
C
B
Time Allowance
.6 HR.
.6 HR.
.6 HR.
.5 HR.
.6 HR
.6 HR.