Setting The Time Program For Central Heating - Viessmann VITODENS Series Operating Instructions Manual

Setting the operating program (central heating)
Press the following keys:
1. for settings; "
2. OK to confirm; "

Setting the time program for central heating

■ The time program for central heating is
made up of time phases. One time
phase from 06:00 to 22:00 h for each
day is set at the factory.
■ You can select up to 4 time phases per
day for standard heating mode. Set the
start and end points for each time
phase. Between these time phases,
the rooms are heated to the frost pro-
tection temperature.
■ You can set the time program individ-
ually.
When setting, bear in mind that your
heating system requires some time to
heat the rooms to the required tem-
perature.
Press the following keys:
1. for settings; "
2. OK to confirm; "
3. / until " " flashes.
4. OK to confirm,
"1234567"
flashes.
" flashes.
" flashes.
" flashes.
" flashes.
3. OK to confirm.
4. / until "
5. OK to confirm; the rooms and DHW
are heated.
5. OK if you want to set the same time
program for every day of the
week
or
/ to select a single day ("1" for
Monday, "2" for Tuesday etc.)
and OK to confirm.
Time phase "1" flashes.
6. / for the required time phase.
7. OK to confirm; Ô appears and the
previously selected start time
or "- - : - -" flashes.
8. / for the required start time.
9. OK to confirm; Õ appears and the
previously selected end time or
"- - : - -" flashes.
10. / for the required end time.
11. OK to confirm.
Note
If you have set a time program for central
heating at the room temperature control-
ler, a time program for at least the same
period must also be set in the control
unit.
Central heating
(cont.)
" flashes.
13