Chapter 6 Operation And Maintenance; Checking The Power Synchronized Unit Status; Device Replacement After Operation Startup; Replacing A Server - Fujitsu ETERNUS DX60 S4 Configuration Manual

Chapter 6
Operation and Maintenance
This chapter describes maintenance and troubleshooting after starting system operation.
6.1

Checking the Power Synchronized Unit Status

Check the LEDs on the power synchronized unit regularly.
6.2

Device Replacement After Operation Startup

This section explains the procedure to replace devices after starting system operation.

• Replacing a Server

• Replacing a Power Synchronized Unit
• Replacing an AC Sensor Unit
CAUTION
6.2.1 Replacing a Server
The following procedure provides an overview of the required work to replace a server, such as when a server
fails. Refer to the relevant manuals for more details.
Procedure
1
Replace the server.
2
Perform the necessary settings for the replacement server.
3
Connect the replacement server to the server UPS unit.
After the procedure is complete, check that power synchronization performs normally if necessary.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Do
• Ask your maintenance engineer to replace devices.
71
Copyright 2017 FUJITSU LIMITED
End of procedure
P3AM-8012-10ENZ0