Connection Procedure When Adding An Eternus Dx/Af - Fujitsu ETERNUS DX60 S4 Configuration Manual

Chapter 5 Adding a Connecting Device

5.2 Connection Procedure When Adding an ETERNUS DX/AF

5.2 Connection Procedure When Adding an ETERNUS DX/AF
This section describes how to connect the power synchronized unit when an ETERNUS DX/AF is added.
For details about ETERNUS DX/AF installation, connection, and settings, refer to one of the following manuals:
• ETERNUS DX60 S4/DX60 S3 Hybrid Storage Systems Configuration Guide (Basic)
• ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Configuration Guide
(Basic)
• ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems Configuration Guide
(Basic)
• ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
• ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
• ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
• ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays Configuration Guide (Basic)
• ETERNUS DX200F All-Flash Arrays Configuration Guide (Basic)
Adding the ETERNUS DX8100 S3/DX8700 S3/DX8900 S3 must be performed by your maintenance engineer.
Do not attempt to add the ETERNUS DX8100 S3/DX8700 S3/DX8900 S3 by yourself.
■ Adding up to four ETERNUS DX/AF storage systems
The connection procedure when up to four ETERNUS DX/AF storage systems are added is described below.
Procedure
1
Set the required settings for power synchronization of the ETERNUS DX/AF storage systems
that are to be added.
For details about the ETERNUS DX/AF settings, refer to
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
"4.1 Setting the ETERNUS DX/AF" (page
67
Copyright 2017 FUJITSU LIMITED
45).
P3AM-8012-10ENZ0