Connecting To The Eternus Dx/Af - Fujitsu ETERNUS DX60 S4 Configuration Manual

Chapter 4 Connection and Settings

4.5 Connecting to the ETERNUS DX/AF

4.5 Connecting to the ETERNUS DX/AF
Connect the power synchronized unit to the ETERNUS DX/AF with the RS232C cable.
Two RS232C cables (1m) are provided with a power synchronized unit. If the length of the cable is too short or
three or more cables are required, purchase more RS232C cables.
Up to four ETERNUS DX/AF storage systems can be connected to each power synchronized unit. When power
synchronized units are cascaded, up to eight ETERNUS DX/AF storage systems can be connected.
CAUTION
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Do
• When connecting external (signal, power, etc.) cables, avoid placing stress on
them. Not doing so may damage the cables.
Do Not
• Do not forcibly bend or fold the cable. Doing so may damage the cable and
cause the power synchronized unit to malfunction.
90
Do not bend
more than 90 degrees
61
Copyright 2017 FUJITSU LIMITED
Do not fold
P3AM-8012-10ENZ0