Mounting Modem Antenna; Approved Parts; Mounting Antenna - Nextel iR1200 Installation Manual

•
To assure compliance with United States FCC regulations on RF exposure, the user
of the equipment must position the antenna in such a way to maintain a separation of
at least 8 inches (20 cms) between the antenna and the human body.
•
Ensure that the antenna is properly installed external to the vehicle and in
accordance with the requirements of the antenna manufacturer/supplier.
•
Use only the supplied or an approved antenna. Unauthorized antennas, modifications
or attachments could impair call quality, damage the modem, or result in violation of
the FCC.

Mounting Modem Antenna

The following table outlines the approved antennas that can be used with the iR1200
modem.
1 RAF4136AMM – Magnetic Antenna
2 FAD5524A – Mobile Window Antenna
3 HAF9067A – Mobile Roof Mount Antenna
4 CLR-877MU – Antenna World Magnetic Mount
5 CLR-853MU – Antenna World Portable antenna
NOTE: Antennas with gain exceeding 3db do not comply with FCC RF exposure
and are not allowed for use with this product.
The following table outlines the steps for mounting an antenna.
1 Use an antenna suitable for the cellular band of frequencies (806-
870 MHz) with Mini UHF jack and matched for 50-ohm impedance.
2 Position the antenna to allow as free a radiation pattern as practical.
3 Screw the male connector of the antenna cable to the MODEM ANT
jack (refer to Figure 3 – Rear Panel Layout).
NOTE: Each antenna has specific installation instructions. Please refer to the
antenna installation instructions for specific requirements and details.
Vehicle Installation
16