Canon XF400 Instruction Manual page 75

Setting the Time Code's Initial Value
If you set the running mode to [
1 Select [Initial Time Code].
> [3 # Recording Setup] > [Initial Time Code]
• The time code setting screen appears with an orange selection frame indicating the hours.
• Touch [Reset] to reset the time code to [00:00:00:00] and return to the previous screen. If the running mode
is set to [ Free Run], the time code will be reset the moment you touch the button and keep running
continuously from 00:00:00:00.
2 Touch [Í] or [Î] to set the value for the hours and then touch the minutes field to select it.
• Change the rest of the fields (minutes, seconds, frame) in the same way.
3 After completing all the fields of the time code, touch [OK].
• Touch [Cancel] to close the screen without changing the time code.
• If the running mode is set to [
the moment you touch [OK].
4 Touch [X].
NOTES NOTES
• When slow & fast motion recording is activated, you cannot select the [
Conversely, when pre-recording is activated, [
• When slow & fast motion recording is activated, the time code signal cannot be output from the SDI OUT
terminal (m only) or HDMI OUT terminal.
• When the camcorder is set to external recording-only mode, the time code mode cannot be set to
[ Regen.].
• When you are using the [
built-in backup battery has some charge left, even if you disconnect all other power sources. However, this is
less accurate than when the camcorder is on.
Preset], you can set the initial value of the time code.
Free Run], the time code will start running from the time code entered
Free Run] is set automatically and cannot be changed.
Free Run] running mode, the time code will continue running as long as the
Setting the Time Code
Free Run] running mode.
75