Canon XF400 Instruction Manual page 138

Menu Options
Menu item
[Monitor Channels]
138
[HDMI Channels]
[Notification Sounds]
[£ Display Setup] menu
Menu item
[Output Terminal]
[HDMI Max Resolution]
[Output Status]
[LCD Brightness]
[LCD Backlight]
[Viewfinder Backlight]
[LCD Mirror Image]
[Output Onscreen Displays]
[Onscreen Markers]
[Distance Units]
Setting options and additional information
[ƒ CH1/CH2], [š CH1/CH1], [Ÿ CH2/CH2], [
[ CH3/CH4], [ CH3/CH3], [
[ CH1+3/CH2+4]
[ƒ CH1/CH2], [ CH3/CH4]
[ High Volume], [ Low Volume], [j Off]
A beep will accompany some of the camcorder's operations.
• While pre-recording is activated, the camcorder will not emit any notification sounds.
Setting options and additional information
[j Off], [ø SDI] (m only), [ù HDMI]
[3840x2160], [1920x1080], [1280x720]
—
Displays a screen where you can check the configuration (video and audio) of the output signal.
Brightness adjustment bar, [ ] (darker), [
• Changing the brightness of the screen does not affect the brightness of your recordings or the
brightness of the playback image on a TV.
[ Bright], [ Normal], [
[ Bright], [ Normal]
Changes the screen's backlight level to one of three levels (LCD screen) or two levels (viewfinder),
affecting the general brightness of the screen.
• Changing the brightness of the screen does not affect the brightness of your recordings or the
brightness of the playback image on a TV.
• [ Bright] is not available for [LCD Backlight] when infrared recording is activated.
[i On], [j Off]
When this setting is set to [i On], this function reverses the image on the screen horizontally
when you rotate the LCD panel 180 degrees toward the subject. In other words, the screen will show
a mirror image of the subject.
[i On], [j Off]
When this setting is set to [i On], the camcorder's onscreen displays will appear also on the
screen of a TV or monitor connected to the camcorder.
[j Off], [4 Level (Gray)], [3 Level (White)], [6 Grid (Gray)],
[5 Grid (White)]
You can display a grid or a horizontal line at the center of the screen. Use the markers as a reference
to make sure your subject is framed correctly (vertically and/or horizontally).
• Using the onscreen markers will not affect the recordings.
[. meters], [/ feet]
Selects the units to use for the focusing distance display while focusing manually. This setting also
affects units for the altitude in the GPS information of geotagged recordings.
CH1+2/CH1+2],
CH4/CH4], [ CH3+4/CH3+4],
] (brighter)
Dim]
(A 110)
(A 110)
(A 108)
(A 108)