Others; Play Timer; Software Update - Panasonic SC-HC400 Owner's Manual

Play timer

You can set the timer so this unit turns on at a certain
time every day.
Preparation
Set the clock.
1
Press [CLOCK/TIMER] repeatedly to select
"TIMER ADJ".
2
Press [3, 4] to set the starting time ("ON TIME")
and then press [OK].
3
Press [3, 4] to set the finishing time
("OFF TIME") and then press [OK].
4
Press [3, 4] to select the music source* and then
press [OK].
Turning the timer on
1
Prepare the selected music source and set the
desired volume.
2
Press [F, PLAY].
≥ "F" is displayed.
To cancel, press [F, PLAY] again.
3
Press [Í] to turn the unit to standby mode.
∫ To check the settings
Press [CLOCK/TIMER] repeatedly to select
"TIMER ADJ".
(During standby, press [CLOCK/TIMER] twice.)

≥ The timer starts at a low volume and increases gradually to
the preset level.
≥ The timer comes on at the set time every day if the timer is
on.
≥ If you turn off the unit and turn it on again while a timer is in
operation, the timer will not stop at the end time.
* "CD", "USB" and "FM" can be set as the music source.

Others

Auto off function
As a factory default, this unit will turn to standby mode
automatically if there is no sound and it is not being
used for approximately 20 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [2, 1] to select "OFF" and then press [OK].

≥ To turn the function on, select "ON" in step 2.
≥ This setting cannot be selected when radio is the source.
≥ When connected to a Bluetooth
not work.
device, the function does
®
Bluetooth standby
®
When "SC-HC400" is selected from a paired
Bluetooth device's Bluetooth
®
on automatically from standby mode and establish a
Bluetooth connection.
®
1
Press [SETUP] repeatedly to select "BLUETOOTH
STANDBY".
2
Press [2, 1] to select "ON" and then press [OK].

≥ To turn the function off, select "OFF" in step 2.
≥ The factory default is "OFF". If this function is set to "ON", the
standby power consumption will increase.
Changing the unit and remote
control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [CD/USB] repeatedly to select "CD".
2
Press and hold [∫] on the unit and [2] on the
remote control until the unit's display shows
"REMOTE 2".
3
Press and hold [OK] and [2] on the remote control
for at least 4 seconds.

≥ To change the mode back to "REMOTE 1", repeat the steps
above but replace [2] with [1].

Software update

Occasionally, Panasonic may release updated
software for this system that may add or improve the
way a feature operates. These updates are available
free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
Checking the software version
Press [SETUP] repeatedly to select "SW VER." and
then press [OK].
The version of the installed software is displayed.
≥ Press [OK] to exit.
menu, this unit will turn
®
TQBJ2049
13