Fluke 7341 User Manual page 68

7341 Calibration Bath
User's Guide
Interface Command Summary Continued
Command Description
Set Cool mode to On
Set Cool mode to Auto
Read HGb mode
Set HGb mode:
Set HGb mode to Off
Set HGb mode to On
Set HGb mode to Auto
Read low set-point limit value
Set low set-point limit to n
Read high set-point limit value
Set high set-point limit to n
Miscellaneous (not on menus)
Read all extended parameters
Read firmware version number
Read all operating parameters
Read structure of all commands
Legend:
Note:
64
Command Command
Format Example
co[ol]=on co=on
co[ol]=au[to] co=au
hg[b] hg
hg[b]=of[f]/on/au[to]
hg[b]=of[f] hg=of
hg[b]=on hg=on
hg[b]=a[uto] hg=au
*tl[ow] *tl
*tl[ow]=n *tl=–40
*th[igh] *th
*th[igh]=n *th=150
all all
*ver[sion] *ver
*all *all
h[elp] h
[] Optional Command data
{} Returns either information
n Numeric data supplied by user
9 Numeric data returned to user
x Character data returned to user
When DUPLEX is set to FULL and a command is sent to READ, the command is returned followed by a
carriage return and linefeed. Then the value is returned as indicated in the RETURNED column.
Returned
Returned Example
hgb:xxx hgb: auto
tl: 999 tl: –40
th: 999 th: 150
list of extended
parameters
ver.9999,9.99 ver.7341,1.00
list of operating
parameters
list of
commands
Acceptable Values
On, Off, Auto
–60 to 20
–150 to 30