Venting Systems; Full Reline With Outside Air - Horizontal; Illustrations Reflect Typical Installations And Are For; Actual Installation May Vary Due To Individual Design - Quadra-Fire SANTAFEI-MBK Installation Manual

Santa Fe Pellet Insert
5

Venting Systems

A. Full Reline With Outside Air - Horizontal
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 16.1 Figure 15.1
NOTE: In Canada, where passage through a wall or partition of
combustible construction is desired, the installation shall conform
to CAN/CSA-B365.
16
NOTE; Use metal plate around
exhaust vent pipe and seal all
edges with non-flammable insu-
lation such as fiberglass, mineral
wool or ceramic.
Do not use high temperature
caulking materials to seal any
edge to prevent furture service-
ability.
Fire Risk.
Inspection of Chimney:
• Masonry chimney must be in good condition.
• Meets minimum standard of NFPA 211
• Factory-built chimney must be a minimum 6 inch
(152mm) UL103 HT.
Optional Outside Air through Rear
Wall (Horizontal)
NOTE:
• Illustrations reflect typical installations and are FOR DESIGN
PURPOSES ONLY.
• Illustrations/diagrams are not drawn to scale.
• Actual installation may vary due to individual design
preference.
7019-230G
WARNING
June 5, 2017