Honda GL1100 Owner's Manual page 62

2. lnsert
a
new oil filter element. Check
that the
O~rings
are in good condition
and that all parts are installed as shown.
3.
Install the oil filter cover and tighten
the oil filter boI!.
Oil Filter Bolt Torque:
27-33 N·m (2.7-3.3 kg-m,
20-24 ft-lb)
4. Perform steps 4 to 6 of Engine Oil
Change.
4. Fill the crankcase with approximately
3.2
liters
(3.4
U.S. quarts) of the
recom~
mended grade oil and install the oil filler
cap.
S. Start the engine and let it idle for a
few minutes.
6. Stop the engine. Make sure the oil
level is at the upper level mark and
there are no oil leaks.
NOTE:
When running in very dusty conditions,
oil changes should be performed more
frequently than specified in the main·
tenance sched
J.
OIL FILTER
NOTE:
... Change th~ oil filter after draining
engine oil.
I. Remove the oil filter bolt, and pull
the oil filter element
(I)
out of the
oil filter cover.
(1) Filter element
(2)
O-rings
- -