What To Do Next - Cisco ASR 9000 Series Configuration Manual

How to Configure Serial Interfaces
Command or Action
Step 7
configure
interface serial interface-path-id.subinterface
pvc dlci
encap [cisco | ietf]
commit
Example:
RP/0/0RP0RSP0/CPU0:router# configure
RP/0/0RP0RSP0/CPU0:router (config)# interface
serial 0/1/0/1.1
RP/0/0RP0RSP0/CPU0:router (config-subif)# pvc
20
RP/0/0RP0RSP0/CPU0:router (config-fr-vc)# encap
cisco
RP/0/0RP0RSP0/CPU0:router (config-fr-vc)#
commit
Step 8
show frame-relay pvc dlci-number
Example:
RP/0/0RP0RSP0/CPU0:router# show frame-relay pvc
20
Step 9
show policy-map interface serial
interface-path-id.subinterface {input | output}
or
show policy-map type qos interface serial
interface-path-id.subinterface {input | output}
Example:
RP/0/0RP0RSP0/CPU0:router# show policy-map
interface serial 0/1/0/0.1 output
or
RP/0/0RP0RSP0/CPU0:router# show policy-map type
qos interface serial 0/1/0/0.1 output

What to Do Next

•
Modifying the Keepalive Interval on Serial Interfaces
Perform this task to modify the keepalive interval on serial interfaces that have Cisco HDLC or PPP
encapsulation enabled.
When you enable Cisco HDLC or PPP encapsulation on a serial interface, the default keepalive interval
Note
is 10 seconds. Use this procedure to modify that default keepalive interval.
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
526
To modify the default Frame Relay configuration on serial interfaces that have Frame Relay
encapsulation enabled, see the
section of the "Configuring Frame Relay on the Cisco ASR 9000 Series Router"
manual.
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Purpose
Repeat Step 1 through Step 6 to bring up the serial
subinterface and any associated PVC at the other end of the
connection.
The configuration on both ends of the subinterface
Note
connection must match.
(Optional) Verifies the configuration of specified serial
interface.
(Optional) Displays the statistics and the configurations of
the input and output policies that are attached to a
subinterface.
"Modifying the Default Frame Relay Configuration on an Interface"
module in this
OL-26061-03