Connecting Speakers - Denon PMA-30 Owner's Manual

Contents Connections

Connecting speakers

NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers. Also, turn off the subwoofer.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. ("Protection circuit" (v p. 51))
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0 Use speakers with impedance of 4 - 16 Ω/ohms.
o Connecting the speaker cables
Carefully check the left (L) and right (R) channels on the speakers
being connected to this unit, and be sure to connect the polarities
correctly.
1
Peel off about 10 mm of sheathing from the tip of the
speaker cable, then either twist the core wire tightly or
terminate it.
Front panel Display
Playback Settings
2
Turn the speaker terminal counterclockwise to loosen
it.
3
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
19
Rear panel
Tips
Remote Index
Appendix