Table of Contents
Advertisement
Warning!
Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do not run
your vehicle in the garage while
programming the transceiver. Exhaust gas
can cause serious injury or death.
Your motorized door or gate will open
and close while you are programming the
universal transceiver. Do not program the
transceiver if people, pets or other objects
are in the path of the door or gate. Only
use this transceiver with a garage door
opener that has a "stop and reverse"
feature as required by Federal safety
standards. This includes most garage door
opener models manufactured after 1982.
Do not use a garage door opener without
these safety features. Call toll-free
1-800-355-3515 or, on the Internet at
HomeLink.com for safety information or
assistance.
Programming The
System
Note:
When programming a garage door
opener or a gate, disconnect the power
to these devices before programming.
Continuous operation of the devices
could damage the motor.
The HomeLink system provides three
buttons which can be individually
selected and programmed using the
transmitters for current, on-market
devices as follows:
1. Disconnect power to the device
being programmed.
2. Position the end of your handheld
transmitter one to three inches (2.5 -
7.5 cm) away from the HomeLink
button you wish to program while
keeping the indicator light in view.
3. Simultaneously press and hold both
the chosen HomeLink and hand-held
transmitter buttons. Do not release
the buttons until step four has been
completed.
04060102-121-999
HomeLink Buttons
1 — First HomeLink Button
2 — Second HomeLink Button
3 — Third HomeLink Button
4. After the HomeLink indicator light
changes from a slow to a rapidly
blinking light, release both the
HomeLink and hand-held transmitter
buttons.
Note: If the HomeLink indicator light
does not change to a rapidly blinking
light, contact HomeLink at
www.homelink.com or call
1-800-355-3515 for assistance.
5. Connect power to the device being
programmed.
6. Firmly press and hold the
programmed HomeLink button for five
seconds, and then release it. Perform
this operation two times to activate the
door or gate. If the door or gate does not
activate, press and hold the just-trained
HomeLink button and observe the
indicator light. If the indicator light stays
on constantly, programming is complete
and your device should activate when
the HomeLink button is pressed and
released.
Note:
To program the remaining two HomeLink
buttons, begin with step one.
7. If the indicator light blinks rapidly for
two seconds and then turns to a
constant light, continue with
"Programming" steps (see below) to
complete the programming of a rolling
37
Advertisement
Table of Contents
