Advertisement
ASSEMBLY INSTRUCTIONS
1
2
Do Not Screw
M8* Bolt & Nut
2
MODEL# 9315TS - TRAMPOLINE
1
Do Not Screw
M8* Bolt & Nut
Do Not Screw
M8* Bolt & Nut
STEP 1:
Gather all 12 Curved Top Rails (Part 2), flip
them over so the spring holes are touching
the floor. Separate them into 3 groups of 4
Top Rails. Make sure to place them all on a
flat and secure surface before you begin.
NOTE:
The Curved Top Rail has 8 spring holes in the
top section. The bottom should be smooth.
Connect both ends of the Top Rail by
attaching to the T-Section (Part 3)
STEP 2:
Secure all 3 parts by screwing M8 Bolt (Part
4) with the Nut facing toward the center of
the trampoline.
STEP 3:
Once you have created 3 groups, place
them on a safe and flat floor as shown.
NOTE:
Openings on the top rail must remain
facing the floor until Step 7 when you are
ready to flip them over.
NOTE:
Do not screw in M8* Bolt and Nut on the
T-Section until Step 7, this will allow you
to insert all 3 groups together once the
U-Shaped Legs are installed.
3
Top
Bottom
5
Advertisement
