108
2. Instrument cluster
Instrument panel brightness adjustment
■
The instrument panel brightness levels when the tail lights are on and off can be adjusted
individually. However, when the surroundings are bright (daytime, etc.), turning on the tail
lights will not change the instrument panel brightness. At this time, any adjustments made
to the instrument panel brightness levels will be applied to both settings at once.
Dimming the analog speedometer lighting
■
The analog speedometer lighting will be dimmed when the ambient light is bright, such
as during the daytime, and SPORT S or SPORT S+ mode is selected.
Outside temperature display
■
In the following situations, the correct outside temperature may not be displayed, or the
●
display may take longer than normal to change.
• When stopped, or driving at low speeds (less than 12 mph [20 km/h])
• When the outside temperature has changed suddenly (at the entrance/exit of a
garage, tunnel, etc.)
When "− −" or "E" is displayed, the system may be malfunctioning.
●
Take your vehicle to your Lexus dealer.
Pop-up display
■
In some situations, such as when a switch operation is performed, a pop-up display will
●
be temporarily displayed on the multi-information display.
Some pop-up displays can be set on/off. (→P. 126)
●
Liquid crystal display
■
Small spots or light spots may appear on the display. This phenomenon is characteristic
of liquid crystal displays, and there is no problem continuing to use the display.
Customization
■
The meter display can be customized on the multi-information display. (→P. 117)
NOTICE
To prevent damage to the engine and its components
■
Do not let the indicator of the tachometer enter the red zone, as it represents the
●
engine speed range which exceeds the maximum safe engine speed.
In the following situations, the engine may be overheating. In this case, immediately
●
stop the vehicle in a safe place, and check the engine after it has cooled completely.
(→P. 630)
• The engine coolant temperature gauge indicator (
ing.
• The engine oil temperature gauge indicator (
) is in the red zone and flash-
) is in the red zone and flashing.