Compressor Ptc Starter & Overload Protector; Sensor & Fan - EdgeStar AFR151SS Service Manual

3. DISASSEMBLY
(Models：AWC241FD)
4、 Loosen screws. Pull out the rear air duct cover.
(figure 32)
Carbon Filter
fan
t
sensor
screw
5、
Loosen screw. You can replace the sensor & fan.
(figure 33)
wire housing
screw
Heater r
evaporator
3-11 COMPRESSOR PTC STARTER & OVERLOAD
PROTECTOR
(Models：AFR151SSOD, AFR151SS,ABR151SG,
AWC151SZ, ABR241SG, AWC241SZ，AFR241SS，
AFR241SSOD)
1. Open the box near compressor, the starter and overload
protector are located inside. (figure 34)
2. Dismantle the compressor PTC starter and overload
3. The compressor PTC starter and overload protector is like
Figure 32
(Models：AWC241FD)
1、 Open the box near compressor, The starter and overload
Figure 33
- 18 -
Figure 34
protector. (figure 35)
below. (figure 36)
protector are located inside. (figure 37)
Figure 35
Figure 36
Figure 37