Disassembly; Glass Shelves; Wires Shelves - EdgeStar AFR151SS Service Manual

3. DISASSEMBLY

3-1 DOOR
(Models：AFR151SSOD, AFR151SS, ABR151SG,
AWC151SZ, , ABR241SG, AWC241SZ, AFR241SS,
AFR241SSOD, AWC241FD
Loosen 2 bolts securing the lower door axis to the lower
hinge to remove the door. (Figure 1)
(Models：AWC241TSZ)
Loosen 2 bolts securing the lower door axis to the lower
hinge to remove the door. (Figure 2)

3-2 GLASS SHELVES

(Models：AFR151SSOD, AFR151SS, ABR151SG,
ABR241SG)
 Open the door completely.
 Lift either the left or right side of the shelf creating a 45◦
angle from its original position. Make sure not to lift either
side of the shelf too hard as it may come in contact with the
inner wall mount.
 Pull the shelf outward until it is removed from the inner
compartment. You may encounter some resistance from
the shelf guard rail. (figure 3)
Lower Door Axis
Figure 1
BOLT
Figure2
Metal guide post
Figure 3
(Model：AFR241SS, AFR241SSOD)
1. Open the door completely.
2. Remove all of the contents loaded on the shelf, if
applicable.
3. With the shelf pushed all the way to the rear of the
unit, position the cutouts in the left & right sides of the
shelves
under the plastic posts on each side of the shelf track.
4. Push down on the front of the shelf while lifting up
on the rear of the shelf (picture a seesawing motion)
until the
shelf passes over the plastic posts.
5. Pull the shelf forward until it is completely removed
from the inner compartment.

3-3 WIRES SHELVES

(Model：AWC151SZ, ,AWC241SZ)
 you must pull the shelves approximately 1/3 out of the rail
compartment.

To remove the shelves out of the rail, pull each shelf
approximately 1/3 out. Use a long flat screwdriver to press
down the right plastic notch as shown in Figure 3 and at the
same time lift the left plastic notch as shown in Figure 4.
Then proceed to pull out the shelf slowly. (figure 4)
- 13 -
(figure 5)
:
Figure5
Figure 4