To Wire And Mount The Thermostat - Carrier Connect Installation Manual

Hydronic Fan Coil

To wire and mount the thermostat

1
Turn off 24 Vac power at the equipment circuit breaker or the system switch.
2
Place the thermostat base against your wall to mark drill holes.
NOTE To cover a horizontal 2" x 4" electrical box, install accessory wallplate.
3
Drill the anchor holes or use existing holes to mount the wallplate.
Drywall — Drill 3/16" hole for the anchor.
○
Plaster — Drill 7/32" hole for the anchor.
○
4
Pull wires through opening in base.
Carrier Connect™
Wi-Fi Thermostat
Installation Guide
Carrier Proprietary and Confidential
7
Wiring the Carrier® Connect™ Wi-Fi Thermostat
CARRIER CORPORATION ©2017
All rights reserved