Important Points - Poulan Pro 115259826 Instruction Manual

S Remove dirt, stones, loose bark, nails,
staples, and wire from the tree where
cuts are to be made.
Plan a clear retreat path
Direction of Fall
45_
FELLING LARGE TREES
(6 inches in diameter or larger)
The notch method is used to fell large
trees. A notch is cut on the side of the tree
in the desired direction of fall. After a felling
cut is made on the opposite side of tree,
the tree will tend to fall in the direction of
the notch.
NOTE: If tree has large buttress roots,
remove them before making the notch. If
using saw to remove buttress roots,
keep saw chain from contacting ground
to prevent dulling of the chain.
NOTCH CUT AND FELLING TREE
S Make notch cut by cutting the top of
the notch first. Cut through
diameter of the tree. Next complete
the notch by cutting the bottom. See il-
lustration. Once the notch is cut, re-
move the wedge of wood from tree.
First cut
Notch
Second cut
S After removing the wood from the notch,
make the felling cut on the opposite side
of the notch. This is done by making a
cut about two inches higher than the
center of the notch. This will leave
enough uncut wood between the felling
cut and the notch to form a hinge. This
hinge will help prevent the tree from fal-
ling in the wrong direction.
Hinge holds tree on stump and
helps control fall.
Closing of
notch
NOTE: Before felling cut is complete,
use wedges to open the cut when
necessary to control the direction of fall.
To avoid kickback and chain damage,
use wood or plastic wedges, but never
steel or iron wedges.
S Be alert to signs that the tree is ready
to fall: cracking sounds, widening of
the felling cut, or movement in the up-
per branches.
S As tree starts to fall, stop saw, put it
down, and get away quickly on your
planned retreat path.
DO NOT
S
tially fallen tree. Be extremely cautious
with partially fallen trees that may be
poorly supported. When a tree doesn't
fall completely, set saw aside and pull
down tree with a cable winch, block and
tackle, or tractor.
CUTTING A FALLEN TREE
(BUCKING)
Bucking is the term used for cutting a fall-
en tree to the desired log size.
WARNING:
log being cut. Any portion can roll caus-
ing loss of footing and control. Do not
of the
1/3
stand downhill of the log being cut.

IMPORTANT POINTS

S Cut only one log at a time.
S Cut shattered wood very carefully;
sharp pieces of wood could be flung
Final cut here
toward operator.
S Use a sawhorse to cut small logs. Nev-
er allow another person to hold the log
while cutting and never hold the log
with your leg or foot.
S Do not cut in an area where logs, limbs,
and roots are tangled. Drag logs into a
Hinge
clear area before cutting them by pulling
out exposed and cleared logs first.
BUCKING TECHNIQUES
WARNING:
pinched or hung in a log, don't try to force it
out. You can lose control of the saw result-
ing in injury and/or damage to the saw.
Stop the saw, drive a wedge of plastic or
wood into the cut until the saw can be re-
moved easily. Restart the saw and care-
fully reenter the cut. Do not use a metal
wedge. Do not attempt to restart your saw
when it is pinched or hung in a log.
Use a wedge to remove pinched saw
Opening
of felling
cut
Turn saw OFF and use a plastic or
wooden wedge to force cut open.
9
use your saw to cut down a par-
Do not stand on the
If saw becomes