Limbing And Pruning - Poulan Pro 115259826 Instruction Manual

Overcutting begins on the top side of the
log with the bottom of the saw against the
log. When overcutting use light downward
pressure.
Overcutting Undercutting
Undercutting involves cutting on the un-
derside of the log with top of saw against
the log. When undercutting use light up-
ward pressure. Hold saw firmly and main-
tain control. The saw will tend to push
back toward you.
WARNING:
Never turn saw upside
down to undercut. The saw cannot be
controlled in this position.
Always make your first cut on the com-
pressions side of the log. The compres-
sion side of the log is where the pressure
of the log's weight is concentrated.
First cut on compression side of log
Second cut
First cut on compression side of log
BUCKING WITHOUT A SUPPORT
S Overcut through of the diameter of
1/3
the log.
S Roll the log over and finish with a sec-
ond overcut.
S Watch for logs with a compression
side to prevent the saw from pinching.
See illustration above for cutting logs
with a compression side.
BUCKING USING A LOG OR
SUPPORT STAND
S Remember your first cut is always on
the compression side of the log.
(Refer to the illustration below for your
first and second cut)
S Your first cut should extend
diameter of the log.
S Finish with your second cut.
Using a log for support
Using a support stand

LIMBING AND PRUNING

Second cut
WARNING:
against kickback. Do not allow the mov-
ing chain to contact any other branches
or objects at the nose of the guide bar
when limbing or pruning. Allowing such
contact can result in serious injury.
WARNING:
to limb or prune. Do not stand on lad-
ders, platforms, a log, or in any position
which can cause you to lose your bal-
ance or control of the saw.
IMPORTANT POINTS
S Watch out for spring poles. Spring
poles are small size limbs which can
whip toward you or pull you off bal-
ance. Use extreme caution when cut-
ting small size limbs.
S Be alert for spring back from any
branches that are bent or under pres-
sure. Avoid being struck by the branch
or the saw when the tension in the
of the wood fibers is released.
1/3
S Frequently clear branches out of the
way to avoid tripping over them.
10
nd
2 Cut
st
1 Cut
nd
2 Cut
nd
2
st
1
st
1 Cut
nd
2 Cut
Be alert for and guard
Never climb into a tree
st
1 Cut
Cut
Cut