Replacing The Logo - Electro-Voice EVID-S5.2XB Installation Manual

2.
3.5

Replacing the logo

An additional logo is included, horizontal installation is shown.
To replace the logo, do the following:
1.
2.
3.
4.
5.
Electro-Voice
If 8 ohm mode is desired, remove the safety screw.
Safety screw (A) is shown in the previous step.
Remove the existing logo.
Clean the surface with alcohol.
Align the logo with the logo recess on the grille.
Remove the paper backing.
Insert the logo.
Press firmly to ensure the logo is applied.
Installation manual
en 11
2017.08 | 01 | F.01U.345.358