Setting The Diffserv Mode Supported By Mpls L2Vpn - Huawei Quidway S9300 series Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
By default, the DiffServ mode supported by the MPLS L3VPN is uniform.
----End

2.14.3 Setting the DiffServ Mode Supported by MPLS L2VPN

Context
You need to set the DiffServ mode supported by the MPLS L2VPN according to the actual
situation of the network.
Procedure
l
l
----End
Issue 04 (2011-12-26)
NOTE
On F-series boards, when the DiffServ mode is set to short-pipe, a maximum of four domains (with domain
IDs 0 to 3) can be configured. If more than four domains are configured, the MPLS short-pipe mode does
not take effect after the device restarts. You can query the domain ID by using the display diffserv
domain.
VLL networking
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The AC interface view is displayed.
3. Run:
diffserv-mode { pipe { mpls-exp mpls-exp | domain ds-name } |
{ [ mpls-exp mpls-exp ] domain ds-name } | uniform [ domain ds-name ] }
The DiffServ mode applied to the VLL network is set.
By default, the DiffServ mode applied to the VLL network is uniform.
VPLS networking
1. Run:
system-view
The system view is displayed.
2. Run:
vsi vsi-name
The VSI view is displayed.
3. Run:
diffserv-mode { pipe { mpls-exp mpls-exp | domain ds-name } |
{ [ mpls-exp mpls-exp ] domain ds-name } | uniform [ domain ds-name ] }
The DiffServ mode applied to the VPLS network is set.
By default, the DiffServ mode applied to the VPLS network is uniform.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 MPLS LDP Configuration
short-pipe
short-pipe
88