Configuring The Ingress For A Static Lsp - Huawei Quidway S9300 series Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
The setup of static LSPs does not require the label distribution protocol or exchange any control
packet. Thus, the static LSPs consume little resources and are applicable to small-scale networks
with simple and stable topology. The static LSPs cannot vary with the network topology
dynamically. The administrator, therefore, needs to adjust the static LSPs according to the
network topology.
Static LSPs and static CR-LSPs share the same label space (16 - 1023).
Static LSPs are used over the MPLS L2VPN.
For information about the MPLS L2VPN configuration, refer to the Quidway S9300 Terabit
Routing Switch Configuration Guide - VPN.
Pre-configuration Tasks
Before configuring static LSPs, complete the following tasks:
l
Data Preparation
To configure static LSPs, you need the following data.
No.
1
2
3
4
5
6

1.3.2 Configuring the Ingress for a Static LSP

To set up a static LSP, you need to configure the ingress node.
Context
Do as follows on the LSR to be configured as the ingress:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
static-lsp ingress lsp-name destination ip-address mask-length { nexthop next-hop-
address | outgoing-interface interface-type interface-number } out-label out-label
Issue 04 (2011-12-26)
Configuring the static unicast route or an IGP to connect LSRs on the network layer
Data
Name of the static LSP
Destination address and mask
Value of incoming label or outgoing label on each LSR
Next hop address or outgoing interface on the ingress
Incoming interface, next hop address, or outgoing interface on the transit node
Incoming interface on the egress
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Static LSPs Configuration
3