Gear Selector Override - Dodge RAM PROMASTER CITY 2018 User Manual

4. Pull the steering wheel outward until it is
in the end of the travel position, then lock
the steering column in position, push the
control handle up until fully engaged.
5. Using the Allen Key, undo the lower steer-
ing column cover screws, and remove the
lower cover.
6. Pull the release tab downwards using one
hand and with the other one remove the
key, sliding it outwards.
7. Once the key is removed, reinstall the
steering column cover.
CAUTION!
It is advisable to contact your authorized
dealer to have the reinstall procedure car-
ried out. If you would like to proceed in
performing the reinstall procedure special
attention must be paid to the correct cou-
pling of the clips. Otherwise damage to the
cover or noise might be heard due to incor-
rect fastening of the lower cover.

GEAR SELECTOR OVERRIDE

If a malfunction occurs and the gear selector
cannot be moved out of the PARK position,
you can use the following procedure to tem-
porarily move the gear selector:
1. Turn the engine OFF.
2. Firmly apply the parking brake.
3. Using a screwdriver or similar tool, care-
fully separate the gear selector boot from
the center console.
Gear Selector Boot Location
4. Press and maintain firm pressure on the
brake pedal.
5. Insert a small screwdriver or a similar tool
into the gear selector override access hole
(at the right front corner of the gear selec-
tor assembly), then push and hold the
override release lever down. While holding
the override release lever down, push the
lock button on the gear selector and move
the gear selector to the NEUTRAL
position.
Gear Selector Override Access Hole
105