Samsung GT-E2330B Service Manual page 25

1
9 ) Twist LOWER to left/right and remove
UPPER lower hook
2) Pass slide FPCB to LOWER insertion
hole, and separate LOWER
1
1) Be careful not to make scratch and molding damage!
12
1) After turning over slide FPCB and RCV +
MOT assy FPCB connector actuator,
remove FPCB horizontally
1) Beware that you do not damage FPCB
2
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
10 1
) Remove insulation tape attached to LCD
lower PCB
1) Be careful not to make scratch and molding damage!
13
1
) After separating MOTOR using detach
point, separate RECEIVER FPCB from
UPPER
Detach point
1) Beware that you do not damage FPCB
7-3
7. Level 2 Repair
1
2