Delta 33-890 Instruction Manual page 14

3. Place wrench (F) Fig. 19, between inner flange (G),
and outer flange (H) and tighten arbor nut (E). Make
certain wrench (F) is above the table surface. If
necessary raise track arm.
4. Loosen cuttinghead clamp knob (J) Fig. 20 and
move cuttinghead (C) to the front of track arm (K).
Loosen track arm locking lever (L), pull out on track arm
index knob (M) and rotate track arm (K) until wrench (F)
is over left table bracket (N). Make certain wrench (F) is
in the vertical position and tighten knob (J) and lever (L)
Fig. 20.
5. Using wrench (D) Fig. 21 as a feeler gage, lower the
track arm assembly by turning handle (P) until wrench (F)
just touches wrench (D). IMPORTANT: Do not raise or
lower track arm any further until table brackets are
adjusted.
6. Loosen track arm locking lever (L) Fig. 20, pull out on
track arm index knob (M) and rotate track arm (K) until
wrench (F) Fig. 22 is directly above rear table bracket (N).
Tighten knob (J) and lever (L) Fig. 20. Using wrench (D)
Fig. 22 as a feeler gage, check to see if the height of the
cuttinghead (C), at the rear of the table bracket (N) is the
same height as the front table bracket.
G
E
L
M
K
F
N
F
D
P
F
N
14
H
F
Fig. 19
J
C
Fig. 20
Fig. 21
C
D
Fig. 22