Safety Aspects Of Connections; Regulatory Information - Pace Xi5 User Manual

SAFETY INFORMATION (cont.)

Safety aspects of connections

Full details of the rear panel are on page 6.
Connecting
To ensure correct operation, use this set-top box only with the Pace-
approved power supply unit provided. If you use an unapproved
alternative, you will invalidate the warranty.
Always connect the cord from the power supply unit to your set-top box
before you insert the power supply unit into the wall socket-outlet.
Disconnecting
To disconnect power from your set-top box, always remove the power
supply unit from the wall socket-outlet (i.e. rather than remove the cord
from your set-top box). Therefore you must install your set-top box near to
the wall socket-outlet, which should be easily accessible.
If you are in any doubt about the power supply cord, its plug or its
connection, or are not certain that the electrical outlets you are using
are properly wired and grounded, consult a qualified electrician before
proceeding any further.
The model and serial number and electrical rating of your set-top box are
on a label on its base.
WIFI
Users should be advised that high-power radars are allocated as primary
users (i.e. priority users) of the bands 5250-5350 MHz and 5470-
5725 MHz and that these radars could cause interference and/or damage
to the LE-LAN device.
The device for operation in the band 5150-5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems.

Regulatory information

Part 15 of FCC rules
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC RF Radiation Exposure Statement
MPE/SAR/RF Exposure Information.
This equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment.
This equipment was verified for RF exposure and found to comply with
Council Recommendation 1999/519/EC and FCC KDB 447498 D01
General SAR Exclusion Guidance.
WARNING: While this equipment is in operation, a separation distance
of at least 20 centimeters (equal to 8 inches) must be maintained
between the antenna inside the equipment and the bodies of all
persons exposed to the antenna in order to meet the FCC RF exposure
guidelines. Making changes to the antenna or the equipment is not
permitted. Doing so may result in the equipment exceeding the FCC
RF exposure guidelines. This equipment must not be co-located or
operated in conjunction with any other antenna or radio transmitter.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void your authority to operate
this equipment. Failure to heed the Safety Information provided by
failing to connect to a properly wired outlet may void the manufacturer's
warranty.
Pace Xi5 (PX051AEI) USER GUIDE (DRAFT-160208)
NOTE
5